Was considering the statcounter installation step again today and thought i may as well display your ip address during the project setup step. This makes the setup of your statcounter alot easier because you can just copy and paste your IP right then and there.
You get a much clearer picture of your statistics if you filter out your own hits.
So i went back and threw in a little code that brings it up for you.
-steve campisi
You get a much clearer picture of your statistics if you filter out your own hits.
So i went back and threw in a little code that brings it up for you.
-steve campisi
No comments:
Post a Comment
Note: only a member of this blog may post a comment.